|
CONFETTI PRODUCTS

Special: 25%
off all confetti supplies!!!!
| SE887 |
AEROFETTI
Large square cut tissue which stays in the air the
longest and flutters like butterflies or falling leaves. since its size averages about 1
1/2" square, it is the most visual to the audience. Not suited for use in the Pocket
Cannon. 8 oz. package. |
|
Pkg:
$7.50 |
Dozen
Pkgs: $81.00 |
| White |
[Add to Cart] |
[Add to Cart] |
| Purple |
[Add to Cart] |
[Add to Cart] |
| Yellow |
[Add to Cart] |
[Add to Cart] |
| Orange |
[Add to Cart] |
[Add to Cart] |
| Black |
[Add to Cart] |
[Add to Cart] |
| Green |
[Add to Cart] |
[Add to Cart] |
| Multi |
[Add to Cart] |
[Add to Cart] |
| SE884 |
REGULAR CONFETTI
small 1/4" sized white paper bits.
Confetti biodegrades at about the same rate as a newspaper. Due to its small size, the
material is not easily seen by the entire audience, therefore, it is best used for close
up work in small stage areas. 8 oz. package. |
White |
Pkg:
$4.75
[Add to Cart] |
Dozen
Pkgs: $50.95
[Add to Cart] |
| Multi |
Pkg:
$11.00
[Add
to Cart] |
Dozen
Pkgs:
$118.80
[Add
to Cart] |
| SE897 |
AEROSNOW CONFETTI Basically lightweight plastic material, white
in appearance, resembling snowflakes. It is best used indoors, in fiesta launchers that
are filled to capacity. Other uses are for set design and snow drums. It melts from high
heat, but does not burn. It is also waterproof. 8 oz. package. |
pkg:
$4.00
[Add to Cart] |
Dozen
Pkgs: $43.25
[Add to Cart] |
| |
|
| BACK PRESSURE CAP
A thin paper cap that fits externally over
the barrel of a confetti cannon. Holds back pressure until enough is built up to fore the
pressure cap to blow off and a sound is heard. The back pressure cap fits over the muzzle
end of the barrel and must be taped, air tight, in place with masking tape. One cap is
required for each firing, some are reusable if you can find them! |
SE882 |
2 inch
|
Pkg 12:
$6.00
[Add to Cart] |
| SE886
|
1 inch
|
Pkg 12:
$3.00
[Add to Cart] |
| LIFTING CUPS
A thick double-backed paper cup that fits inside
the barrel and acts as an elevator and lifts the payload up evenly. When it lifts, it
spreads open and holds back the gas by forming a tight inner wall seal. This maximizes
your pushing power because no gas escapes between the paper products inside. the cup also
provides a small cargo area that lifts some of the payload to a high point and then dumps
it. One cup is required for each firing, some are reusable if you can find them. |
SE881 |
Pkg 12:
$12.00 |
[View Cart]
TOP
next
page  |